Teddbots Logo

Troubleshooting

  1. a) Check connection if any trip in MCB
  2. b) Check Control panel
  3. c) Check for loose connection
  4. d) Release emergency button
  1. a) Check earthing given to the machine & Control & Pump House
  1. a) Check union are tight
  1. a) Check correction position of Rubber beading
  1. a) Check if pump is start
  2. b) If pump is ON then chances of an air lock might be there, open any union partially and let be released. Tighten union again.
  3. c) Open bleeder valve & release some water in Cartridge filter
  4. d) Check if solenoids are getting magnetized by holding a tester.
  1. a) Restart the machine
  1. a) Tighten back roller slowly and give tension to belt
  1. a) Open cover of motor
  2. b) Check if belt is loose
  3. c) Loosen the nuts holding the motor
  4. d) Push the motor in opposite direction & tighten the nuts
  1. a) Check oil level in power pack
  2. b) Adjust main oil flow knob
  1. a) Check solenoid light On & OFF while operating the inclination
  2. b) Adjust the flow of solenoid knob.
  1. a) Open the cartridge filter & Clean the cartridge
  2. b) Replace cartridge back
  3. c) If cartridge is over 12 months, replace with new cartridge
  1. a) Check wire going from HMI to control panel.
  1. a) Check connection if any trip in MCB
  2. b) Check Control panel
  3. c) Check for loose connection
  4. d) Release emergency button
  1. a) Check connection if any trip in MCB
  2. b) Check Control panel
  3. c) Check for loose connection
  4. d) Release emergency button
Responsive Footer